multivariate survival analysis by Clinicopath module
Posted: Thu Oct 08, 2020 2:58 am
Hi, Thank you for the exellent Clinicopath and Jsurvival module.
I have a question while performing multivariate survival analysis by Clinicopath module.
As you can see from the top of the attached photo, I have entered the appropriate parameters, but an error is displayed in the result window.
As shown in the figure below, when I entered another variable in the continous explanatory variable, the result was well displayed.
However, as you know, multivariate analysis should be performed with variables that are significant as a result of univariate analysis. There are many cases where there is no cotinous variable among the significant variables.
In this case, it may not be possible to perform multivariate analysis. I'm asking if there is any way to fix this.
Thanks again. Wait for your answer.
I have a question while performing multivariate survival analysis by Clinicopath module.
As you can see from the top of the attached photo, I have entered the appropriate parameters, but an error is displayed in the result window.
As shown in the figure below, when I entered another variable in the continous explanatory variable, the result was well displayed.
However, as you know, multivariate analysis should be performed with variables that are significant as a result of univariate analysis. There are many cases where there is no cotinous variable among the significant variables.
In this case, it may not be possible to perform multivariate analysis. I'm asking if there is any way to fix this.
Thanks again. Wait for your answer.