(Mac)Render-area cuts off full visual representation
Posted: Thu Apr 08, 2021 2:25 pm
Good day,
I am using the latest version of Jamovi for mac. When a table or a plot becomes too wide for the standard area where it is rendered into it just gets cut off. Exporting it as pdf shows the same issue, and I seem to be unable to expand the area where my results are shown. This applies to any module I use.
I assume I am overlooking some basic option somewhere, but after looking around I just can't find where I may fix this issue. Thank you for helping out a newcomer!
I attached a screenshot to illustrate the issue.
I am using the latest version of Jamovi for mac. When a table or a plot becomes too wide for the standard area where it is rendered into it just gets cut off. Exporting it as pdf shows the same issue, and I seem to be unable to expand the area where my results are shown. This applies to any module I use.
I assume I am overlooking some basic option somewhere, but after looking around I just can't find where I may fix this issue. Thank you for helping out a newcomer!
I attached a screenshot to illustrate the issue.