"the condition has length > 1" message on SEMLj interactive
Posted: Sun Apr 28, 2024 2:11 am
Hi!
I use jamovi on Linux Fedora 40 KDE. I attempted to adjust a model using SEMLj interactive. When I include ordinal or nominal integers to calculate a SEM model, the message "the condition has length > 1" appears at the top of the output, and no further action can be taken. However, when I change the level of measurement to continuous, the warning message does not appear. Nevertheless, I cannot request a correct adjustment because the continuous data is not coerced to ordinal for using DWLS. Previously, I could perform this calculation without issue, and a note stating "Variable (...) has been coerced to ordered type" was present at the bottom of the "Models Info" table.
Would you be able to assist me with that issue, please?
Cheers,
Alex
I use jamovi on Linux Fedora 40 KDE. I attempted to adjust a model using SEMLj interactive. When I include ordinal or nominal integers to calculate a SEM model, the message "the condition has length > 1" appears at the top of the output, and no further action can be taken. However, when I change the level of measurement to continuous, the warning message does not appear. Nevertheless, I cannot request a correct adjustment because the continuous data is not coerced to ordinal for using DWLS. Previously, I could perform this calculation without issue, and a note stating "Variable (...) has been coerced to ordered type" was present at the bottom of the "Models Info" table.
Would you be able to assist me with that issue, please?
Cheers,
Alex