jTransform long to wide results in incorrect new dataset - Help or Bug?
Posted: Mon May 13, 2024 10:34 am
Hello there,
i am trying to create a new wide dataset from a long dataset using jTransform. I have several cases with the same identifier, as I have collected data at different times for the same variables. When I input the data, the preview shows the correct transformed dataset.
When I create the new dataset, some new variables do not show the right values, but the cells show either 0 or -0. These are the variables I created by the jamovi function compute variable. Some variables show other values, which are not always correct or are missing altogether. These are the variables which were saved after conducting reliability analysis.
What could be going on there? Is it a fault on my part or a bug or a combination of the two?
Thanks in advance for any suggestions!
i am trying to create a new wide dataset from a long dataset using jTransform. I have several cases with the same identifier, as I have collected data at different times for the same variables. When I input the data, the preview shows the correct transformed dataset.
- Bildschirmfoto 2024-05-13 um 12.24.08.png (209.04 KiB) Viewed 6436 times
When I create the new dataset, some new variables do not show the right values, but the cells show either 0 or -0. These are the variables I created by the jamovi function compute variable. Some variables show other values, which are not always correct or are missing altogether. These are the variables which were saved after conducting reliability analysis.
- Bildschirmfoto 2024-05-13 um 12.25.10.png (176.03 KiB) Viewed 6436 times
Thanks in advance for any suggestions!