jamovi

I am a newbie in jamovi.
I always used R but am currently looking for faster ways to perform simple analysis.
The problem is that in jamovi no plots are displaying. It just keep on loading for the whole eternity.
I searched the forum and also generically searched google and found no clue.

I attached a screen shot. This happens to any plot I try in jamovi. Tables are ok though.
I am currently using gnu/linux.
Any thoughts?

Hi, if you change to ordinal or continuous does it work?

David wrote:Hi, if you change to ordinal or continuous does it work?

Hi David.
No. It doesn't.

can you post an omv file?

hmm, this is unusual. we don't normally have these sorts of issues on linux.

did you install from flathub (or from the ppa)? also, what distro are you using?

with thanks

David wrote:can you post an omv file?

Here you go.

jonathon wrote:hmm, this is unusual. we don't normally have these sorts of issues on linux.

did you install from flathub (or from the ppa)? also, what distro are you using?

with thanks

I've installed it from flathub and I am using Trisquel 9.

could you try running jamovi at the terminal, and see it produces any error output when it tries to plot?

the command is:

flatpak run org.jamovi.jamovi

with thanks

jonathon wrote:could you try running jamovi at the terminal, and see it produces any error output when it tries to plot?

the command is:

flatpak run org.jamovi.jamovi

with thanks

The following:

Error in private$.resourcesPathSource(name, "png") :
locale::facet::_S_create_c_locale name not valid

ah ok, are you using what might be considered a 'minimal install'?

try this:

https://forum.sinusbot.com/kb/23

with thanks